The Ultimate Battle-Ready Combat Robot Weapon Motor
The RDY-5536 Hubmotor is an evolution beyond anything available for combat robots before. Enter the space age, with high-strength 7075 aerospace aluminum construction. Massive bearings. Battle-hardened epoxied magnets. Ultra-flexible high-temp silicone wires. Zero weapon belts. These are just some of what you get with your very own hubmotor!
What's Included when you buy a Complete Motor:
- 1X RDY-5536 complete motor, combat-ready out of the box!
- 1X RDY-5536 7075 aluminum clamp ring
- 6X M4 weapon clamp screws
-
*NOTE* This motor is intended to be mounted to a rigid robot frame component and as such does not come with a mounting plate or bracket. You must design to mount BOTH SIDES of the motor to your robot, with frame rails exactly 36mm apart.
-
Optional: Add Snaggletooth 6" AR500 Blade
Tech specs:
- Dimensions: 55mm diameter, 36mm length
- Stator Size: Roughly 28 x 12mm (similar to 3536 can motors)
- Weight: 212 grams (7.5 oz, 0.47 lb) with bullet connectors
- Gigantic 6805 bearings with >600 lbf static, >900 lbf dynamic load ratings
- KV: 1200kV
- Voltage: 3S-6S with appropriate ESCs.
- Recommended ESCs
- For 4S and under 4" blades the 35A ESC or 45A ESCs have been tested to work.
- Beyond 4" blades and/or beyond 4S voltage a 50A or greater ESC is recommended.
- Use 8X M5 bolts, or 8X SHORT THREAD 6mm shoulder bolts for mounting to your robot frame. MAKE ABSOLUTELY SURE NOT TO USE SCREWS THAT THREAD TOO FAR IN OR YOU WILL DESTROY THE MOTOR COILS!
- No circlips, belts, or set screws!
- Super strong, curved neodymium magnets
- Epoxied magnets for extra durability
- High-temperature copper windings
- 18AWG, 18 cm (~7 inch) long silicone wires rated to 200 degrees C
- NEW: 3X 3.5mm bullet connectors, male preinstalled on the motor, and female included for your ESCs
- Winding Resistance: 1200kV ~111 milliOhms
- Designed for use with 6mm or 1/4" thick weapon blades. Thinner can be used with a spacer, and thicker will be fine but will be offset from center and may require longer M4 flathead clamping screws. Max recommended thickness 0.5inch or 12.7mm.
Find the 3D model here: https://grabcad.com/library/rdy-5536-battle-ready-combat-robotics-hubmotor-just-cuz-robotics-1
